EHI ehi tstk Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Configures the stroke calibration interval. The stroke calibration interval is one of the conditions that results in an automatic stroke calibration. An An automatic stroke calibration is performed under the following conditions: The plot is the first plot since the device has been reset. The stroke calibration interval ( the time between automatic stroke calibrations ) has expired. One of the NVS parameters laser power, beam slope or beam curve has been modified. The exposure has been modified. This parameter is available.

Please issue the appropriate monitor command to determine this parameter's default value.

Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.

30-May-2006 Setting the stroke calibration interval to zero disables the automatic stroke calibration for all conditions. The device may have to be reset for this to take place. For example, if this parameter is set to zero after a failed stroke calibration, then stroke calibration may not be disabled on subsequent plots until it succeeds. Normal

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:23:56 2008 PST